|
raviwfc (November 30, 1999 at 12:00 am)
The wires youre talking about are from previous trials..theyre heat sinks and are not connected to anything...I just used the connectors at the bottom of that setup as I have 18 leads going into the WFC. Check the bifilar wound pics on overunity thread where you can see the new connectors are before and after the 9 inductors.
R.
rednaell (November 30, 1999 at 12:00 am)
are the mosfet transistors situated outside the box with blue lid? I noticed that you have 2 red +ve wires and a green -ve wire for supply. then you have other 2 yellow and 1 green wire coming out from that box. Are these these 3 wires going to 3 mosfets, and you are switching them alternatingly to drive the coils and cell?
raviwfc (November 30, 1999 at 12:00 am)
I havent tried to measure the frequencies...it was done totally based on visual generation and volumetric measurements...the freq gen settings would vary with the water you use...I've tried different water from various sources..tap, stream, lake, underground(bore well),... the settings vary for all these...there is no thumb rule frequency as such. The tap water at your place would vary from mine due to the variation in the contaminants present...
rednaell (November 30, 1999 at 12:00 am)
why you say notting about the frequency you use ?
raviwfc (November 30, 1999 at 12:00 am)
Its a 10A 12V DC converter from 240V AC mains. The freq gen would work even on a car battery so it doesnt matter where you get the DC input from. I've tried it with a car battery as input and it works fine.
R.
mjchauffe (November 30, 1999 at 12:00 am)
Hello again Ravi. Can you give us specific details and specs of the power supply which you used to power your D 14 pulse generator circuit in the video? (brand name details if possible?)
What is the max amp range and impedance of your power supply? Thanks.
raviwfc (November 30, 1999 at 12:00 am)
the one you see in the above vid is the D14 crt with the inductors...the VIC addition and bifilar winds on the inductors improved the efficiency even more...didnt post that info due to the risks involved :( ...but someone from panacea had posted the pics of my bifilar inductors generation on the overunity (dot) com thread....this addition increased the efficiency by 10CC for 20 secs at 0.5A 12V I/P to the freq gen. and there was further improvement with the VIC addition after this.
R.
raviwfc (November 30, 1999 at 12:00 am)
Will do.
RF...no.....the frequency of your WFC depends on the build and the water contaminants...sound complicated but once you build it its easy to find the right point for max generation after youve conditioned the tubes..
R.
raviwfc (November 30, 1999 at 12:00 am)
As per Stans Canadian Patent... 2 parallel tubes are 3.75 times more efficient than plates and concentric tubes (ie more than 2 tubes) are 2.5 times more efficient than plates.
SS 316L seamless tubes are pretty expensive....you could try SS 304L seam less but the brown muck generation would not stop for a long time compared to 316L
R.
raviwfc (November 30, 1999 at 12:00 am)
Yes D14 crt ...but add the VIC as per Stans US patent 4936961...he gives detailed specs of the VIC build.
R. |
